Message Board
Message 4 of 4
Posted by member Marie O'Connell Hardy Editor on Wednesday 16 October 2013
Thanks Si.
HOC Ed.
Add your comment
Message 3 of 4
Posted by member Simon Kidd on Tuesday 15 October 2013
Hi Nicholas.
It sounds as if your bilge pump is located under the cockpit sole - there is usually an inspection hatch either at the aft end of the cockpit sole - of just within the area under the engine well. Others are located within teh fuel tank well under the engine.
The bilge pump was an optional extra and thus most were fitted by dealers and owners, so thier location does vary.
Si.
Add your comment | ^Top
Message 2 of 4
Posted by member Marie O'Connell Hardy Editor on Sunday 1 September 2013
Hi Nicholas,
Have you had a look in the engine well where the inspection hatch is ? You might have missed it - you have to lean right in to the well and you will find the little circular cover on the inside of the deck where it drops down in to the well.
Some people just fit them in the well itself, but under the deck is the lowest point and if you get a torch once you take the cover off, you should be able to see down in to the bilges and find something there.
Simon (HOC Secretary) will be the best person to advise and he will no doubt make a posting to you as well. I will email him.
All the best,
Marie
HOC
Editor
Add your comment | ^Top
Message 1 of 4
Posted by member Nicholas Duffin on Sunday 1 September 2013
This sounds daft but I can't find the bilge pump in my Family Pilot 20! I can hear it and it works but I can't see it anywhere and I would like to check its wiring.
Is there a usual place that they are fitted?
Nicholas
Add your comment | ^Top
You must be logged in to post to the Hardy Motor Boat Owners Club message board.
Click here to login in. If you’re not yet a HOC member then why not
join us today?
